BPJQP - 463070032, EPOXY PA PRIMER COATING VOC COMP

  • MSDS: BPJQP
  • Manufacturer: AKZO COATINGS INC
  • Product Name: 463070032, EPOXY PA PRIMER COATING VOC COMP
  • National Stock Number: 8030-00N021602
Product Identification

Product ID:463070032, EPOXY PA PRIMER COATING VOC COMP
MSDS Date:04/24/1990
FSC:8030
NIIN:00N021602
MSDS Number: BPJQP

Responsible Party
AKZO COATINGS INC
434 W. MEATS STREET
ORANGE, CA 92661
US

Emergency Phone: 714-637-1750; CHEMTREC 800-424-9300

Info Phone: 714-637-1750

Cage: 98502

Contractor
AKZO COATINGS INC
ORANGE, CA 92661 US

Telephone: 714-637-1750; CHEMTREC 800-424-9300

Cage: 98502

Ingredients

OCCUP OVEREXP TO SOLV W/PERM BRAIN & NERV SYS DMG.

RTECS: 9999999ZZ


HAS RECOM CMPDS CONTAINING INSOLUBLE CHROMIUM BE

RTECS: 9999999ZZ


HLTH STUDIES HAVE SHOWN THAT MANY PETROL HYDROCARB

RTECS: 9999999ZZ


PERSON TO PERSON. CHLOROCARBON MATLS HAVE PRDCED

RTECS: 9999999ZZ


COULD HAVE SIMILAR EFFECT IN HUMANS. ADRENOMIMETICS

RTECS: 9999999ZZ


FOR LIFE-SUSTAINING USES IN HUMANS ACUTELY OR

RTECS: 9999999ZZ


AN EMPTY DRUM. ALUMINUM IS NOT AN ACCEPTABLE

RTECS: 9999999ZZ


TANKS THAT WILL BE USED TO HNDL PROD. DO NOT HNDL

RTECS: 9999999ZZ


NO SMOKING IN AREA OF USE. DO NOT USE IN GEN

RTECS: 9999999ZZ


UV RADIATION MAY CAUSE FORMATION OF HCL AND/OR

RTECS: 9999999ZZ


REMOVE DECOMPOSITION PRODUCTS FORMED DURING WELDING

RTECS: 9999999ZZ


SKIN CONTACT. LIQUID MAY PENETRATE SHOES

RTECS: 9999999ZZ


INTENTIONAL MISUSE BY DELIB CONC & INHALING CONTENTS

RTECS: 9999999ZZ


SILICA GEL; (AMORPHOUS SILICA)

CAS: 112945-52-5

RTECS: VV7310000

Fraction By Weight: <5%

OSHA PEL 6 MG/M3 TDUST (MFR)

ACGIH TLV: 10 MG/M3 TDUST (MFR)


1); (STRONTIUM CHROMATE)

CAS: 7789-06-2

RTECS: GB3240000

Fraction By Weight: 15-30%

OSHA PEL 0.1 PPM CRO3;CEILING

ACGIH TLV: 0.0005MG CR/M3;A2;93

EPA Report Quantity: 10 LBS

DOT Report Quantity: 10 LBS


TITANIUM OXIDE; (TITANIUM DIOXIDE)

CAS: 13463-67-7

RTECS: XR2275000

Fraction By Weight: <5%

OSHA PEL 15 MG/M3 TDUST

ACGIH TLV: 10 MG/M3 TDUST; 9293


100.

CAS: 71-55-6

RTECS: KJ2975000

Fraction By Weight: 25-40%

OSHA PEL 350 PPM;450 PPM STEL

ACGIH TLV: 350 PPM;450 PPM STEL

EPA Report Quantity: 1000 LBS

DOT Report Quantity: 1000 LBS


3.3.

CAS: 108-94-1

RTECS: GW1050000

Fraction By Weight: 15-30%

OSHA PEL S, 50 PPM

ACGIH TLV: S, 25 PPM; 9293

EPA Report Quantity: 5000 LBS

DOT Report Quantity: 5000 LBS


SILICONE DIOXIDE; (FLUX CALCINED DIATOMACEOUS EARTH

CAS: 68855-54-9

Fraction By Weight: 5-20%

OSHA PEL 0.08 MG/M3 (MFR)

ACGIH TLV: 0.08 MG/M3 (MFR)


TALC (POWDER), CONTAINING NO ASBESTOS FIBERS

CAS: 14807-96-6

RTECS: WW2700000

Fraction By Weight: <5%

OSHA PEL 2 MG/M3 RDUST

ACGIH TLV: 2 MG/M3 RDUST


AROUND LIGHTS. VAPS & FUMES MAY BE IRRIT

RTECS: 9999999ZZ

Hazards

LD50 LC50 Mixture:NONE SPECIFIED BY MANUFACTURER.
Routes of Entry: Inhalation:YES Skin:YES Ingestion:YES
Reports of Carcinogenicity:NTP:YES IARC:YES OSHA:NO
Health Hazards Acute and Chronic:ACUTE: PRLNGD CONT W/SKIN MAY LEAD TO
EXTRACTION OF NATURAL OILS W/RESULTANT MILD IRRIT.DRY PIGMENT MAY
CAUSE NUISANCE DUST, WHICH CAN BE IRRIT TO RESP SYS. PRLNGD/RPTD
SKIN CONT MAY CAUSE DERM. PRLNG D/RPTD CONT MAY CAUSE EYE IRRIT.
EXCESSIVE INHAL OF VAPS CAN CAUSE NASAL & RESP IRRIT, DIZZ, WEAK,
(EFTS OF OVEREXP)
Explanation of Carcinogenicity:STRONTIUM CHROMATE: GROUP 1 (IARC);
GROUP 1 (NTP).
Effects of Overexposure:HLTH HAZ: FATIGUE, NAUS, HDCH, POSSIBLE
UNCONSCIOUSNESS, & EVEN ASPHYXIATION. SWALLOWING CAN CAUSE GI
IRRITATION, NAUS, VOMITING, & DIARRHEA. VENTRICULAR ARRHYTHMIA MAY
BE INDUCED AFTER SENSIT TO EPIN EPHRINE. EYE CONTACT MAY CAUSE SEV
IRRITATION, REDNESS, TEARING, BLURRED VISION, & SENSATION OF SEEING
HALOS (ING 8)
Medical Cond Aggravated by Exposure:NONE EXPECTED.

First Aid

First Aid:INHALATION: MOVE TO FRESH AIR. GIVE ARTIFICIAL RESPIRATION IF
NECESSARY. SKIN: WASH WITH SOAP AND WATER. EYE: FLUSH WITH WATER
FOR AT LEAST 15 MINUTES, CONSULT PHYSICIAN. INGESTION: DRINK ONE OR
TWO G LASSES OF WATER TO DILUTE. DO NOT INDUCE VOMITING. CONSULT
PHYSICIAN OR POISON CONTROL CENTER IMMEDIATELY, TREAT
SYMPTOMATICALLY.

Fire Fighting

Flash Point Method:TCC
Flash Point:74.0F,23.3C
Lower Limits:1.1%
Extinguishing Media:FOAM, CARBON DIOXIDE, DRY CHEMICALS.
Fire Fighting Procedures:WEAR NIOSH/MSHA APPROVED PRESSURE DEMAND SCBA
AND FULL PROTECTIVE EQUIPMENT . WATER MAY BE INEFFECTIVE. WATER
SHOULD BE USED TO COOL CNTNRS EXPOS TO FIRE.
Unusual Fire/Explosion Hazard:KEEP CNTNRS TIGHTLY CLSD.ISOLATE FROM
HEAT, SPARKS, ELEC EQUIP & OPEN FLAME. CLSD CNTNRS MAY EXPLO WHEN
EXPOS TO EXTREME HEAT. APPLIC TO HOT SURFS REQS (SUPDAT)

Accidental Release

Spill Release Procedures:REMOVE ALL SOURCES OF IGNITION. AVOID
BREATHING VAPORS. VENTILATE AREA. REMOVE WITH INERT ABSORBENT. WEAR
NIOSH/MSHA APPROVED SCBA W/FULL PROTECTIVE EQUIPMENT.
Neutralizing Agent:NONE SPECIFIED BY MANUFACTURER.

Handling

Handling and Storage Precautions:STORE CONTAINERS OUT OF SUN & AWAY
FROM HEAT, SPARKS, AND OPEN FLAMES. CLOSE CONTAINERS AFTER EACH
USE. CONSULT NFPA CODE FOR ADNL STOR REQUIREMENTS.
Other Precautions:DO NOT TAKE INTERNALLY. USE APPRVD BONDING &
GROUNDING PROC. OBSERVE LBL PREC. KEEP CLOSURES TIGHT & CNTNR
UPRIGHT TO PVNT LEAKAGE. NEVER USE PRESS TO EMPTY-DRUM IS NOT PRESS
VESSEL. AVOID BRTHG SANDI NG DUST. DO NOT WELD/FLAME CUT (ING 16)

Exposure Controls

Respiratory Protection:USE NIOSH/MSHA APPROVED RESPIRATORY DEVICE. SEE
YOUR SAFETY EQUIPMENT SUPPLIER FOR EVALUATION AND RECOMMENDATION.
IN CONFINED AREAS USE NIOSH/MSHA APPROVED AIRLINE RESPIRATOR OR
HOOD.
Ventilation:PROVIDE SUFF VENT TO KEEP VAP CONC BELOW GIVE TLV & LEL.
FOR BAKING FINISHES, EXHST VAPS EMITTED ON HEATING. (ING 20)
Protective Gloves:IMPERVIOUS GLOVES .
Eye Protection:CHEMICAL WORKERS GOGGLES .
Other Protective Equipment:EYE BATH & SHOWER SHOULD BE AVAIL. USE CHEM
RESISTANT APRON, BOOTS/OTHER CLTHG IF NEEDED TO AVOID RPTD/FREQUENT
(ING 21)
Work Hygienic Practices:WASH HANDS BEFORE EATING, SMOKING OR USING
WASHROOM.
Supplemental Safety and Health
EXPLO HAZ: SPECIAL PREC. DURING EMER CNDTNS OVEREXP TO DECOMP PRODS MAY
CAUSE HLTH HAZ. SYMP MAY NOT BE IMMED APPARENT. OBTAIN MED
ATTN.THERMAL DECOMPOSITION PRODUCTS MAY INCL HCL & PHOSGENE .CN
DTNS TO AVOID:COATINGS CONTAINING HALOGENATED SOLVENTS. MATLS TO
AVOID: HYDROLYSIS & PRODUCES CORROSIVE ACID.

Chemical Properties

HCC:F4
Boiling Pt:B.P. Text:>165F,>74C
Vapor Pres:ING 4 & 5
Vapor Density:HVR/AIR
Spec Gravity:1.5
Evaporation Rate & Reference:SLOWER THAN ETHER
Appearance and Odor:NONE SPECIFIED BY MANUFACTURER.
Percent Volatiles by Volume:56.7

Stability

Stability Indicator/Materials to Avoid:YES
STRONG ACIDS, BASES, OXIDIZERS, AND ALUMINUM COMPOUNDS, METALLIC
ALUMINUM AND ZINC POWDERS. WATER CAUSES SLOW (SUPDAT)
Stability Condition to Avoid:H*2O CONTAM, ALUMINUM CNTNRS, PUMPS &
PIPES. HIGH PRESS SPRAY EQUIP MADE OF ALUMINUM COMPONENTS FOR
APPLIC OF (SUPDAT)
Hazardous Decomposition Products:THERM/PYROLYTIC DECOMP WILL PRODUCE
CO, CO*2, HCL, PHOSGENE, CHLORINE, SMOKE AND NO*X.

Disposal

Waste Disposal Methods:INCINERATE IN AN APPROVED FACILITY. DO NOT
INCINERATE CLOSED CONTAINERS. DISPOSE OF IN ACCORDANCE WITH
FEDERAL, STATE, AND LOCAL POLLUTION CONTROL REQUIREMENTS.

Disclaimer (provided with this information by the compiling agencies):
This information is formulated for use by elements of the Department
of Defense. The United States of America in no manner whatsoever,
expressly or implied, warrants this information to be accurate and
disclaims all liability for its use. Any person utilizing this
document should seek competent professional advice to verify and
assume responsibility for the suitability of this information to their
particular situation.